La-crosse-technology WS-2510 Bedienungsanleitung

Touch Screen Wireless Weather Station WS-2510 Operating instructions

103.1.1. General settings Illumination settings To switch on the illumination, press any touch screen field on the display. The illumination will no

11Illumination time for AC adaptor operation The illumination time for AC adaptor operation (“line”) is displayed in the “LIGHT” field (touch screen

12Calibration of the rainfall reading indicator The rainfall measuring system is delivered with a very high accuracy, so that normally no calibration

13Setting the air pressure display units The display units for air pressure are shown in touch screen field 11 on the right hand side next to the air

144 1 32 The seconds are automatically set to zero. - The WWVB reception can also be switched on or off by means of the “WWVB” touch screen field as

153.2. Normal display function The diagram below shows an example of the normal weather station display. In the following description of the indivi

163.2.1.2. Outdoor sensors (fields 3 to 6) The top right hand field of the display is associated with the outdoor wireless sensors for t

174. Here, the “Graph” symbol shows that the trend display for the wind direction has been selected in the history field. It only appears if i

18The maximum values the last 8 days are displayed. 3. Here, the “Graph” symbol shows that the trend display for the air pressure has been se

191 2 3 1 231 Please note: - With temperature and pressure, the history is shown referred to the current value. Here the display can optionally be i

2Contents 1. General information and functioning ... 3-5 Quick overv

20123.2.9. Time/Date The display field for the time/date is situated at the bottom center of the display: 24h format

21Example for the display of minimum values. Display min/max values - The display mode is selected by touching the appropriate fie

223.4. Programming mode (entering alarm values) You can program the weather station so that an audible-visible alarm occurs when certain minimum or

233.4.2. Setting/Resetting the MIN/MAX alarm values - After activating one of the alarm value displays (MIN or MAX), touch the value field for which

243.4.4. Alarm initiation, Alarm reset - If the measured value exceeds or falls below one of the set alarm values, the display will go off and the

254. Changing batteries Base station If the flat battery symbol appears in the display (see page 9) all batteries must be changed for ones of the sa

26Rotate the weather station a little if required, and if reception is bad, locate it away from electric motors, electrical machines, televisions, co

279. Technical data Measuring interval:... approx.3 min Transmission frequency:.

28meteorological office or by calculation: absolute air pressure ±0.11hPa per meter of the measuring location above/below mean sea level). Wind chil

29WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and w

31. General information and functioning The WS-2510 Touch Screen Wireless Weather Station represents a high-quality, extremely convenient universal

41 4 2 3 1.1. 42.1.12 9111014 208 18 15 16 17 19 13 5 6 7 3 Other - Confirmation tone for touch screen operation can be selected to on or off. - C

5Weather station connection pane, mounting arrangements and battery compartment. The indoor/outdoor sensor system of the

6Setting up/Wall mounting Depending on requirements, the weather station can be hung on a vertical surface (wall) by means of the hanging eyes or set

7ensures optimum reception in the initialization phase. If the signal from the sensor is unable to be received within this time, then the reception i

8electronics. The upper part of the housing can now be placed so that the solar cell is on the same side as the magnet, with the electronic part dire

9 2.3.8 Information on the storage of solar cell powered outdoor sensors These sensors receive their operating voltage from a solar cell that charg