La-crosse-technology WS-7211U Bedienungsanleitung Seite 1

WS-7211U Wireless 433 MHz Weather Station Instruction Manual

10 Resetting Min and Max Temperatures To reset both the minimum and maximum temperatures—press and hold the “MIN/MAX” button for 5 seconds. Adding A

11TX3UP will monitor the temperature of water or soil via a probe. When setting up multiple remote temperature sensors, it is important to remove the

12Weather Forecast The weather forecasting feature is estimated to be 75% accurate. The weather forecast is based solely upon the change of air press

13Weather Icons There are 3 possible weather icons that will be displayed in the FORECAST LCD: Sunny—indicates that the weather is expected to im

14weather will be rainy). The weather icons change when the unit detects a change in air pressure. The icons change in order, from “sunny” to “partly

15arrow pointing down indicates that the air pressure is decreasing and the weather is expected to become worse or remain poor. No arrow means the pre

16Indoor Weather Station The indoor weather station comes with the table stand already mounted. If you wish to use the table-stand all that is requi

17Problem: No outdoor temperature is displayed. Solution: 1. Remove all batteries, reinsert into remote temperature sensor first, then into the indo

18environments. The indoor sensor is less responsive to ambient air currents because of the shielding effect of the display's case. In addition,

19MAINTENANCE AND CARE INSTRUCTIONS • Extreme temperatures, vibration, and shock should be avoided to prevent damage to the units. • Clean displays

2TABLE OF CONTENTS Topic Page Quick Setup 3-5 Inventory of Contents 6-7 Detailed Setup Guide Battery Installation 7 Setting the Time 8 Features

20SPECIFICATIONS Transmitting Frequency 433MHz Measuring Temperatures Indoor Weather Station 32°F to 156.2°F with 0.2 °F resolution Remote Temperatur

21Station Dimensions: (L x W x H) Indoor Weather Station 5.5” x 3.2” x 1.25” (140 x 81 x 32 mm) Remote Temperature Sensor 1.57 x 0.85 x 5.00 in. (1

22The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd’s auth

23center. La Crosse Technology, Ltd will pay ground return shipping charges to the owner of the product to a USA address only. Your La Crosse Techno

24does not cover the cost of installation or removal from a fixed installation, normal set-up or adjustments, claims based on misrepresentation by the

25For warranty work, technical support, or information contact: La Crosse Technology 2809 Losey Blvd. S. La Crosse, WI 54601 Phone: 608.782.1610 Fax:

26FCC DISCLAIMER This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not

3QUICK SETUP Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the indoor temperature station and remote temperatu

4In this time the indoor temperature station and remote temperature sensor will start to talk to each other and the display will show both the indoor

5feet of resistance and an interior wall can have up to 20 feet of resistance. Your distance plus resistance should not exceed 80 ft. in a straight l

6INVENTORY OF CONTENTS 1. The indoor weather station (Figure 1) 2. The remote temperature sensor (TX6U) and mounting bracket. (Figure 2) 3. 3 each,

7ADDITIONAL EQUIPMENT (not included) 1. 1 Philips screwdriver. 2. 2 Fresh AA Alkaline batteries. 3. 2 Fresh AA Alkaline batteries DETAILED SETUP

8Setting the time 1. Press and hold the “SET” key for 4 seconds. 2. The hour will flash. 3. Press and release the “+” key to advance th

9FEATURES Minimum and Maximum Temperatures 1. Press and release the “MIN/MAX” button, “MAX” appears between the indoor and remote temperatures. 2. T