La-crosse-technology WS-9025U Bedienungsanleitung

All rights reserved. This handbook must not be reproduced in any form, even in excerpts, or duplicated or processed using electronic, mechanical

SET key • Enter manual setting modes: LCD contrast, time zone, DST ON/OFF, Time reception ON/OFF, 12/24 hour display, manual time setting, calendar

Moon phase icon Alarm time Weather tendency indicator TimeCalendar display Indoor relative humidity in RH% Time reception icon (for WWVB time) Alarm

MANUAL SETTINGS: The following manual settings can be changed when pressing the SET key for: • LCD contrast setting • Time zone setting • DST (Da

DST (DAYLIGHT SAVING TIME) SETTING: Note: The DST default is “ON”, meaning that the received time will automatically be adjusted according to Da

MANUAL TIME SETTING: In case the Weather Projection Station cannot detect the WWVB-signal (for example due to disturbances, transmitting distance, e

Icons flashing SNOOZE SETTING: The snooze time can be set OFF to a maximum time of 30 minutes (default is 10 minutes): 1. Use the CH/+ key to se

ALARM SETTING: The alarm time can be set when pressing the ALARM 1 or ALARM 2 key. 1. Press the ALARM 1 or ALARM 2 key until the alarm digits

New Moon Full Moon Small Waxing Crescent Large Waning Gibbous Large Waxing Crescent Small Waning Gibbous First Quarter Las

The icons displayed forecasts the weather in terms of getting better or worse and not necessarily sunny or rainy as each icon indicates. For example

INDOOR RELATIVE HUMIDITY AND INDOOR TEMPERATURE: The indoor temperature and humidity data, the indoor comfort indicator are automatically updated an

Battery compartment LCD Display Function keys WEATHER PROJECTION STATION Instruction Manual INTRODUCTION: Congratulations on purchasing this state

TOGGLING AND RESETTING THE OUTDOOR RECORDINGS: 1. To toggle between the outdoor current, MIN/MAX temperature and humidity data and the times (for

1. The distance of the Weather Projection Station or sensor should be at least 6 feet (2 meters) away from any interfering sources such as computer

• Do not submerge the units in water. • Immediately remove all low powered batteries to avoid leakage and damage. Replace only with new batteries

• This product is only designed to be used in the home as indication of the future weather and is not 100% accurate. Weather forecasts given by thi

of repairs or alterations by someone other than an authorized La Crosse Technology, Ltd authorized service center; (6) units used for other than hom

• WWVB Radio controlled time with manual setting option • Time reception ON/OFF (user selectable) • 12/24 hour time display • DST ON/OFF (dayli

TO INSTALL AND REPLACE BATTERIES IN THE WEATHER PROJECTION STATION The Weather Projection Station uses 3 x AA, IEC LR6, 1.5V batteries. To install a

BATTERY INSTALLATION: 1. First, insert the batteries into the Weather Projection Station (see “To install and replace batteries in the Weather Proj

If the batteries are used as the main power source: 1. Projected image brightness, alarm volume and back-light strength will be weaker when batteri

sensors in the order of set-up, i.e. the first sensor will have the temperature/humidity displayed with the number 1 against it and so on. 5. With

up the Weather Projection Station again. Proceed from step 1 in “Setting Up”,“Battery Installation” or “How to use the Projector Adaptor”. HOW TO U

ALARM 1 keyHOUR/IN keyMIN/OUT keyALARM 2 key DIRECTION key SET keyCH/+ keyDISPL key SNOOZE key as 9,192,631,770 vibrations of a Cesium-133 atom in a